|
|
|
Powerful 9.0 amp 1.1 max HP motor
|
|
|
Light weight, only 26.5 lbs. with
comfortable carrying handle
|
|
|
Capacity to cut up to 1-1/2 in.
diameter holes thru 2 in. steel with
annular cutters, or 1/2 in. diameter
holes, 4-1/4 in. deep with twist drill
bits
|
|
|
Strong two-coil magnet
|
|
|
Two positions for feed handle -
relocate without tools
|
|
|
Simple two-button control panel -
unobstructed by feed handle
|
|
|
|
|
Voltage
|
120 AC
|
|
Amps
|
9.0
|
|
Drill
Capacity
|
1/2 in.
|
|
No
Load Speed
|
450 RPM
|
|
Cord
Type
|
8 ft. Fixed
|
|
Construction
Type
|
Grounded
|
|
Electronic
Feedback
|
Yes
|
|
Tap
Capacity
|
--
|
|
Drill
Point Pressure
|
750 lbs.
|
|
Adjustable
Base
|
No
|
|
Drill
Travel
|
6.6 in.
|
|
Chuck
or Taper
|
Weldon
|
|
Tool
Weight
|
26.5 lbs.
|
|
Shipping
Weight
|
35.0 lbs.
|
|
For remote drilling in metal,
the 4270-20 is a great choice. The entire tool
weighs just 26-1/2 pounds and has a comfortable
carrying handle well positioned for balance,
with cutter wrenches stored on-board. This is a
very portable machine. However, power was not
sacrificed for portability. This drill press
includes a very powerful 1.1 maximum horsepower,
9.0 amp motor. It can drill up to 1-1/2 in.
diameter holes through 2 in. thick steel with
annular cutters, or 1/2 in. diameter holes 4-1/4
in. deep with twist drill bits. The tool is
setup to accept standard 3/4 in. Weldon shank
cutters, or an optional 3-jaw chuck is available
for use with twist drill bits. The strong
two-coil magnet provides 2,300 lbs. of deadlift
force on 1 in. thick steel. The simple
two-button control panel is located on the back,
away from feed handle obstruction. The feed
handle can be conveniently relocated to the
opposite side without the use of tools.
|