FEATURES
	Powerful 9.0 amp 1.1 max HP motor
	Light weight, only 26.5 lbs. with comfortable carrying handle
	Capacity to cut up to 1-1/2 in. diameter holes thru 2 in. steel with annular cutters, or 1/2 in. diameter holes, 4-1/4 in. deep with twist drill bits
	Strong two-coil magnet
	Two positions for feed handle - relocate without tools
	Simple two-button control panel - unobstructed by feed handle

SPECIFICATIONS
Voltage	120 AC
Amps	9.0
Drill Capacity	1/2 in.
No Load Speed	450 RPM
Cord Type	8 ft. Fixed
Construction Type	Grounded
Electronic Feedback	Yes
Tap Capacity	--
Drill Point Pressure	750 lbs.
Adjustable Base	No
Drill Travel	6.6 in.
Chuck or Taper	Weldon
Tool Weight	26.5 lbs.
Shipping Weight	46.0 lbs.

For remote drilling in metal, the 4270 is a great choice. The entire tool weighs just 26-1/2 pounds and has a comfortable carrying handle well positioned for balance, with cutter wrenches stored on-board. This is a very portable machine. However, power was not sacrificed for portability. This drill press includes a very powerful 1.1 maximum horsepower, 9.0 amp motor. It can drill up to 1-1/2 in. diameter holes through 2 in. thick steel with annular cutters, or 1/2 in. diameter holes 4-1/4 in. deep with twist drill bits. The tool is setup to accept standard 3/4 in. Weldon shank cutters, or an optional 3-jaw chuck is available for use with twist drill bits. The strong two-coil magnet provides 2,300 lbs. of deadlift force on 1 in. thick steel. The simple two-button control panel is located on the back, away from feed handle obstruction. The feed handle can be conveniently relocated to the opposite side without the use of tools.